AP.Setup

        Comfast Extender Setup

AP Extender Setup-Comfast Extender Setup-Comfast Wi-Fi Range Extender Setup-AP.Setup

Connect.........
Login Into Ap.Setup Page 73%

Comfast Extender Setup

Comfast Extender Setup is the best answer for all of your internet problems. They progressively boost your wireless network’s signal and disseminate it across your house. As a result, your home’s dead spots will be eliminated by using a repeater.

Using WPS to Set Up a Comfast Wireless Network Repeater

 

  1. Place the Comfast Repeater in close proximity to the Network Signal Access Point ( you can re position once synced)
  2. On your home network, press and hold the WPS button for 5–10 seconds.
  3. (In less than 2 minutes) For 10 seconds, press and hold the WPS button on the Comfast Repeater.
  4. The presence of flashing blue lights on the WiFi signal indicates that the connection is being established.
  5. Plus, connect to the Comfast Network Repeater, which will be called “Home Network.”
  6. For security reasons, you will only have to generate or enter the password once.
  7. Once your WiFi Network Extender is configured, move it as needed.
Comfast Extender Setup

Instructions for Setting Up a Comfast Wifi Access Point

Comfast WiFi Extender with Access Point Setup Instructions

  1. Connect to the COMFAST Wireless Network
  2. Open your browser and put http://192.168.10.1 into the address bar.
  3. Assign the username admin and the password admin.
  4. “AP” is the option to choose.
  5. In the Key area, type your New Network Name, Encryption Type, and a new password, then click “Apply.”
  6. Alternatively, if you have both a 2G and a 5G access point
  7. Allow time for the device to reset.
  8. Use the password you created to connect to the new wireless network you named.
  9. You should be online right now, so take use of it.
  • Click here to connect to the COMFAST Wireless Network.
  • Open your browser and put http://192.168.10.1 into the address bar.
  • Fill in the admin username and password.
  • Now choose “Access Point.”
  • In the Main box below, type your Current Network Name, Encryption Form, and New Password, then click “Apply.”
  • Allow for a system restart.
  • Use the password you set to connect to the new wireless network you created.

For additional information, please visit:

  • Method for manually setting up an ap extender
  • WPS technique for setting up a Victony range extender
  • How can I use https://ap.setup to set up a WIFI repeater?

WPS setup with Comfast range extender:

 

  • The Comfast booster should be placed close to the primary Wi-Fi router.
  • For around 10 seconds, press or hold the wireless protected setup ( WPS ) button on your repeater.
  • Now hit or hold the WPS connection button on the modem or router.
  • Blinking blue LEDs on the WiFi signal indicate that the modem and wireless booster are establishing a connection.
  • Once your gadget has been linked properly. The “Home Network”- PLUS is a hitch that connects to a Comfast Wi-Fi repeater
  • It will prompt you to provide a password for security purposes, which will be required just once.
  • Now that your repeater is fully functional, you may install it wherever you wish.
Comfast Extender Setup